best selling
-
HEM Single Socket IP53 Weatherproof – 10A
IP53 rating provides weather resistance making this product suitable for outdoors.
Power: 10A
Input Voltage: AC 250V -
HEM MR16 Lamp Holder + 20cm Wire
HEM standard lamp holder for a MR16 bulb type with a 20cm wire.
Wire Length: 200mm -
HEM Photocell/ Daylight switch 6A
This light control switch is an auto daylight light sensor switch allowing adjustment of brightness.
Electronic devices are controlled to switch on or off through illumination which turns the light on at night and off in the daytime.Input Voltage: AC 220V
Max Load Current: 6A
Frequency: 50-60Hz
Ambient-light:<5-100lux -
-
56Series L1 MODULE ENCLOSURE COVER IP66
Width 95 mm
Height 95 mm
Depth 28 mm -
HEM GU10 Lamp Holder +30cm Cable
HEM standard lamp holder for a GU10 bulb type with a 30cm wire.
Wire length: 300mm -
![3 Pin Plug to Bare End [1M]](https://mew.co.nz/wp-content/uploads/2025/06/eyJidWNrZXQiOiJ3ZWItbmluamEtaW1hZ2VzIiwia2V5IjoidmVzdGFcL2ltYWdlc1wvcHJvZGltZ1wvMjY5MV8xLmpwZyIsImVkaXRzIjp7InJlc2l6ZSI6eyJ3aWR0aCI6NDgwLCJoZWlnaHQiOjQ4MCwiZml0IjoiaW5zaWRlIiwid2l0aG91dEVubGFyZ2VtZW50Ijp0-300x300.webp)
3 Pin Plug to Bare End [1M]
High quality SAA Approved 3 pin plug to bare end, 3 core 1mm cable, 10A rated. Ideal for engineers,technicians and DIY use.
Cable Size: 1mm
Color: Black
Current rate: 10A
Length: 1M -
16MM SINGLE CORE XLPE CABLE
For mains, sub-mains and sub circuits unenclosed, enclosed in conduit, buried direct or in underground ducts for buildings and industrial plants where not subject to mechanical stress. Suitable where space is at a premium and/or where conditions of overload may occur.
Conductor: Plain annealed copper
Insulation: XLPE X-90
Sheath: PVC 5V-90
Voltage: 0.6/1KV
Standards: AS/NZS 1125, AS/NZS3808 and AS/NZS 5000.1
Voltage: 90°C -
EMERGENCY LIGHTING CONTROLLER 230V
ENYA series
Timer for automatic test of emergency lights
Integrated test key
1 change over contact
Width 17.5mm
Installation designTechnical dataWs Single shot leading edge with control contact
Time ranges
Time range reversible between
10min, 30min, 60min, 90min, 2h and 3h
IP rating IP20
Tightening torque: max. 1Nm
Terminal capacity:
1 x 0.5 to 2.5mm² with/without multicore cable end
1 x 4mm² without multicore cable end
2 x 0.5 to 1.5mm² with/without multicore cable end
2 x 2.5mm² flexible without multicore cable end
5. Input circuit
Supply voltage: 230V AC
Terminals: L-N
Tolerance: -15% to +10%
Rated frequency: 48 to 63Hz
Rated consumption: 2VA (1.0W)
Duty cycle: 100%
Reset time: 500ms
Ripple and noise at DC: –
Drop out voltage: >30% of supply voltage
Overvoltage category: III (in accordance with IEC 60664-1)
Rated surge voltage: 4kV -
PDL Keystone Format Data Jack Clip Module – White
PDL 600 Series were designed and engineered locally in Christchurch, taking into account the specific needs of New Zealand and Australian homes and building.
The plastics used in 600 Series are recycleable so once no longer required, need not place a burden on our landfills.Note: we do have full range of PDL 600 series, please ring us if you need something else.
Colour: White
Vertical Installation
Length: 23mm
Depth: 15.3mm
Material: Polycarbonate -
Reem Budget 12W 850lm, IP20, 4K
REEM Budget series Ceiling / Wall LED circular lamp.
Ideal for Bathroom, Bedroom, Dining, Kitchen, Living Room.
Commercial for cloak rooms, kitchens, hallways, service areas etc.Voltage: 230V, 50/60Hz
Colour: 4000K
Dimension: 250*35mm
Lumen: 850lm
IP20
Power: 12W -
SEDEX 90Cut 10Watt Downlight LED 3CCT
SEDEX combines sleek, modern design with advanced features, making it perfect for any living or working environment.
Crafted from high grade IP44 weather resistant material, SEDEX guarantees longevity and optimal performance for years to come.
SEDEX provides exceptional energy efficiency with up to 80% energy savings which makes it a perfect fit for your home.
Not only does our SEDEX light provide impressive lighting and durability, but it also comes with warranty ensuring peace of mind and reliability.Discover the Brilliance of SEDEX and bring impressive illumination to any space!
Power : 10watt
Voltage : 220-240AC, 50Hz
CCT : 3000K, 4000K, 6000K
Cut : 90mm
Overall : 115mm
Lumens: 850lm
IP rating : IP44
CRI: >80
Dimmable
IC-F
2 YEAR WARRANTY -
TANZINI SINGLE ISOLATING SWITCH 2P 20A IP66
TANZINI IP66 Isolating switch rates at 20A, and meets AS/NZS standards. Good for isolating air condintioner, hot water cylinder, and other applicances.
-
SDocs:V0721-ISO1P20
Voltage: 250V
IP66
Current: 20A
Dimension:85x85x70 mm -
-
CHINT AC Contactor 2 x N/O 2Pole 20A
Din Mount 2P 20 amp Contactor 240V 2 x N/O
-
SURFACE MOUNT FRAME FOR PANEL LIGHT 600*1200*50
HIGH QUALITY SURFACE MOUNT FRME FOR PANEL LIGHTS
SUITS 600*1200mm PANEL LIGHTS. -
CHINT AC Contactor 4 x N/O 4Pole 25A
Din Mount 4P 25 amp Contactor 240V 4 x N/O
-
Aluminium Metal Cover for HEM/HQE OneGang Switch
Aluminium cover applicable for HEM and HQE one gang switch.
-
SDocs:V1019-WS
Size: 74W x 118H (mm)
Material: Aluminium -
-
-
SHENLER DOUBLE POLE RELAY BASE WITH LEVER
Plastic marker clip
-DIN rail mounting -
Digital Check Meter- 40A 36mm-width Single phase
Single phase 36mm-width Digital power check meter.
Reliable method for checking how much power is being consumed.
Complies with IEC62053-21 standard AND IP51 rated for protection against penetration of dust and water.Width: 36mm
Input voltage: 220-250AC
Rated current: 40A
Dinrail mounting -
LEGRAND ISOLATING SWITCH 1P 63A
Isolating switches DX3-IS – from 16 A to 125 A
Double break contactsfor more product information, please click https://www.legrand.co.nz
Product characteristics
Isolating switches – Grey handle
AC 22 A
Can be equipped with 1 DX3 signalling auxiliary
1P – 250 V~
Compatible with prong-type and fork type supply busbars
Nominal rating In : 63 A
Number of modules : 1 -
TANZINI TCG Series Main Isolater 1Pole 100A
Rated Current: 100A
Rated Voltage: 230/400Vac 50Hz
Pole: 1
Degree of protection: IP20
Width: 18mm
Height: 84mm
Depth: 77mm -
TANZINI MCB 1Pole 10A Type-C TCG Series
Rated Current: 10A
Rated Voltage: 230/400Vac 50Hz
Pole: 1P
Type C
Ic=Inc=6kAComply with AS/NZS 60898
-
TANZINI MCB 1Pole 6A Type-C TCG Series
Rated Current: 6A
Rated Voltage: 230/400Vac 50Hz
Pole: 1P
Type C
Ic=Inc=6kAComply with AS/NZS 60898
-
TANZINI TCG Series RCD 2Pole 63A
Rated Current: 63A
Rated Voltage: 230Vac 50Hz
Pole: 1P+N
In=30mA
Ic=Inc=6kAWidth:36mm
Height: 84mm
Depth: 69mmComply with AS/NZS 61008
-
TANZINI TCG Series RCD 2Pole 40A
Rated Current: 40A
Rated Voltage: 230Vac 50Hz
Pole: 1P+N
In=30mA
Ic=Inc=6kAWidth:36mm
Height: 84mm
Depth: 69mmComply with AS/NZS 61008
-
HEM Double Socket IP53 Weatherproof – 10A
IP53 rating provides weather resistance making this product suitable for outdoors.
Power: 10A
Input Voltage: AC 250V -
HEM Single Socket IP53 Weatherproof – 10A
IP53 rating provides weather resistance making this product suitable for outdoors.
Power: 10A
Input Voltage: AC 250V -
HEM BLACK Single Switch IP56 16A
IP56 rating provides high weather resistance for water and dust making this product suitable for outdoors.
Power: 16A
Input Voltage : AC 250VSize:85x85x62mm
-
HEM Single Switch IP56 Weatherproof – 16A
IP56 rating provides high weather resistance for water and dust making this product suitable for outdoors.
Power: 16A
Input Voltage : AC 250VSize:85x85x62mm -
Aluminium Metal Cover for HEM/HQE TwoGang Switch
Aluminium cover applicable for HEM and HQE Two gang switch.
-
SDocs:V1019-WS
Size: 74W x 118H (mm)
Material: Aluminium -
-
Aluminium Metal Cover for HEM/HQE OneGang Switch
Aluminium cover applicable for HEM and HQE one gang switch.
-
SDocs:V1019-WS
Size: 74W x 118H (mm)
Material: Aluminium -
-
HEM 3 GANG PLATE WITH ALUMINIIUM COVER
HEM switchgears has nice design with UV stabilisation and is complete with a high quality plastic cover plate. With a low profile and premium high gloss surface finish, the HEM range makes the site with surface beauty. Australian and New Zealand standards approved. Ideal for the home handyman or professional trade people.
Plate dimensions: 74W x 118H x 10D (mm)
Gang No.: 3
Colour: White -
HEM 1 GANG PLATE WITH ALUMINIIUM COVER
HEM switchgears has nice design with UV stabilisation and is complete with a high quality plastic cover plate. With a low profile and premium high gloss surface finish, the HEM range makes the site with surface beauty. Australian and New Zealand standards approved. Ideal for the home handyman or professional trade people.
Plate dimensions: 74W x 118H x 10D (mm)
Gang No.: 1 -
PDL Keystone Format Data Jack Clip Module – White
PDL 600 Series were designed and engineered locally in Christchurch, taking into account the specific needs of New Zealand and Australian homes and building.
The plastics used in 600 Series are recycleable so once no longer required, need not place a burden on our landfills.Note: we do have full range of PDL 600 series, please ring us if you need something else.
Colour: White
Vertical Installation
Length: 23mm
Depth: 15.3mm
Material: Polycarbonate -
RJ45 Adaptor for HEM plate
RJ45 Adaptor for most NZ CAT5E & CAT6 keystone to suit HEM switchgear plate.
Material: ABS plastic -
HEM SURFACE SINGLE SOCKET WITH MOUNT PLATE – 10A, WHITE
HEM switchgears has nice design with UV stabilisation and is complete with a high quality plastic cover plate. With a low profile and premium high gloss surface finish, the HEM range makes the site with surface beauty. Australian and New Zealand standards approved. Ideal for the home handyman or professional trade people.
Colour: White
Rate: 10A
Input voltage: AC 230V -
HEM DOUBLE POWERPOINT VERTICAL – 10A, WHITE
HEM switchgears has nice design with UV stabilisation and is complete with a high quality plastic cover plate. With a low profile and premium high gloss surface finish, the HEM range makes the site with surface beauty. Australian and New Zealand standards approved. Ideal for the home handyman or professional trade people.
-
SDocs:V0820-WGPO2-DPX
Plate dimensions: 74W x 118H x 10D (mm)
Colour: White
Rate: 10A
Input voltage: AC 230V -
